Medical Gas Plants

Overview

Save huge amount of energy with an appropriate gas plant. We offer medical gas plants for compressed air, vacuum and anesthetic gas scavenging. Compressed air can be used either as medical air, or as energy source for driving surgical tools. The typical plant according to EN ISO 7396-1 or HTM 02-01 usually consists of 2 or 3 compressors/pumps, board for their control, pressure vessel, filtration system and pressure control panel. The design of this medical gas pipeline system enables very reliable functions and offers variable advantages for user, for example:

LOW NOISE LEVEL

The use of a low speed fan and modern techniques of vibro-acoustic optimization has resulted in extremely low noise levels.

SIMPLE TO INSTALL, EASY TO OPERATE

We deliver all components of plant preassembled and ready for operation. On site it is just necessary to connect all components and start up the plant.

PERFECT OVERVIEW OF STATUS

The control board for operation of compressors/pumps and filtration system provide all possible information about the status of plants, like current pressure level, overheating notice, fault of separate component, counter of working hours, etc. It is possible to connect all information to the central gas supervision.

OPTIMIZED PRESSURE CONTROL

Pressure control panel can be combined for medical air and surgical air, or separate for each air source. Double regulators with bypass are installed for each source to assure continuous supply in case of service or maintenance of any component.

PERFECT AIR QUALITY

The water separator and coalescing filters remove free water and particles down to 0.01 micron and eliminate oil droplets down to 0.01 ppm. A heatless desiccant dryer reduces moisture content to a pressure dew point of -40 °C, removing any risk of condensation, bacteria and mould growth. A dual cleaning stage includes activated carbon to eliminate hydrocarbons (oil vapor, smells). A catalyst then converts CO into CO2. A particle filter at the exit removes particles which may have been introduced in the desiccant stages down to 0.01 micron.

HIGH EFFICIENCY COMPRESSORS

We use compressors/pumps, which are designed and manufactured to meet the industry’s expectations of the highest quality standards. They have been designed to be service friendly with direct and easy access to all components. Wear out of parts is reduced to a minimum.

ENERGY SAVING

The most important function for a gas plant is that the operation and capacity of all components are synchronized, because in that way the consumption of energy is as low as possible. Therefore we offer special control boards for operation of compressors, pumps and filtration systems.